Speed: 0.6 ppm black, 4 mpp color
Memory: 512 KB
Graphics: 600 X 600dpi black, 300 x 300 color
Left: .25 inch
Right: .25 inch
Top: 0.04 inch
Bottom: .59 inch A4, Letter, Legal, .84 all other (left margin on envelopes)
Standard Feeders: One Paper Tray [capacity: 1/2" stack]
Using Index Cards and Postcards
Using the Single Envelope Slot
The printer allows you to load up to 20 envelopes at a time in the IN tray or to feed a single envelope through the printer without first removing the paper from the IN tray by using the single envelope slot. When using the single envelope slot, you can alternate printing on an envelope then on a piece of paper. This feature is useful when printing a series of letters and their corresponding envelopes.
The single envelope slot allows you to print on either a No. 10 (COM-10) or a DL size envelope. Other envelope sizes are not supported with the single envelope slot.
NOTE: Do not remove the paper from the IN tray, and be sure the card guide is down before using the single envelope slot.
Loading Envelopes in the IN Tray
|The resume light is blinking||The
printer is out of media (paper).
The media (paper) is improperly loaded.
The top cover of the printer is open.
The print cartridge is improperly installed.
paper or media in the printer's input tray and press the RESUME
button on the printer control panel.
Remove and reload the media, then press the RESUME button.
Close the top cover and press the RESUME button.
Make sure the print cartridge snaps into place with the green arrow aligned with the dot on the cradle top. Then push the RESUME button.
|Both lights are on||The printer failed||Turn off the printer and turn it on again. If the lights stay on, contact a service person.|
|Both lights are off.||The printer is improperly connected to a power source.||Make sure the power module plug is firmly inserted into the printer's power socket, and the other end of the cord is plugged into an outlet. Turn the power on by pressing the POWER button.|
|The RESUME and POWER lights blink alternately.||The
printer is in an unknown state.
An inappropriate printer driver is selected.
The media is jammed in the printer.
The print carriage is unable to move.
The printer failed or the computer-to-printer connection failed.
the printer off by pressing the POWER button.
Cancel the print job at the computer and turn the printer
Select the HP Printer Driver.
Remove the jammed media.
Turn off the printer, open the printer's top cover, and remove anything blocking the movement of the print carriage. Gently move the print carriage to the left and back again with your hand. Then, turn on the printer.
Turn off the printer, disconnect the interface cable from the printer, and turn the printer back on. If the lights continue to blink, the printer has failed. Otherwise the problem my be with the interface cable.
The interface connection is located on the back of the printer.
Connection: Macintosh DIN