PCL Level 4
Auto rotate: Not Available
Duplex: Not Available
RET: Not Available
Fonts Per Page: 8 (Each attribute is a separate font)
|Courier||12 pt. (10 pitch)||Medium Upright||P & L||Roman -8|
To check fonts available in printer, press the Test Print button located on the side of the printer, above the interface connector.
Left: 47 dots (0.157") portrait, 60 dots (0.2") landscape
Right: 95 dots (0.315") portrait, 60 dots (0.2") landscape
Top: 150 dots (0.5") portrait & landscape
Right: 150 dots (0.5") portrait & landscape
Standard Trays: 1 paper tray (100 Sheets)
Through manual feed slot at
the back of printer.
Some paper sizes may require special software support.
|11||Paper Out||Add Paper|
|12||Printer Open||Close Cover Firmly|
|13||Paper Jam||Open printer and remove jammed paper, press Continue|
|14||No toner cartridge or toner not seated properly||Insert toner cartridge firmly into place|
|PC||Printer received a request for a paper size that does match the paper tray||Insert correct paper tray or press Continue to override|
|PF||Printer received command to manual feed a sheet of paper||Feed paper through manual feed slots or press Continue to override|
|PE||Printer received request to manually feed an envelope||Feed envelope through manual feed slots or press Continue to override|
|FC||Font cartridges were removed while printer was off-line and contained data||Insert font cartridge and press Continue|
|FE||Font cartridges were removed while printer was on-line||Turn the printer off and then back on|
|20 & 21||Printer out of Memory||Press continue. Data may be lost. Print less complicated pages, less soft fonts, or at a lower graphics resolution|
|22 & 40||Communications error||Check baud rate and protocol|
|41, 51, 52, 53, 54, 55, 60 - 67||Operational error||Contact HP|
Connection: Centronics Female
Activation: Set SW1 switch 1 to the ON position
Connection: DB-25 Configured at factory for RS-232, RS-422 available by removing removing rear panel, and moving the jumpers from positions 1 and 3 (counting from left) to positions 2 and 4.
Activation: Set SW1 switch 1 to the OFF position