LaserJet
Plus LaserJet
Plus | Language:
PCL Level 4 Speed: 8ppm Memory: 512KB standard Graphics: 300dpi Autorotate: Not Available Duplex: Not Available RET: Not Available |
Fonts Per Page: 16 (Each attribute is a separate font)
Internal Fonts
| Typeface | Size | Variation | Orientation | Symbol Set |
| Courier | 12 pt. (10 pitch) | Medium Upright | P & L | Roman -8 |
| Medium Upright | P & L | USASCII | ||
| Medium Upright | P & L | ROM EXT | ||
| Line Printer | 8.5 pt. (16.67 pitch) | Medium Upright | P | Roman-8 |
| Medium Upright | P | USASCII | ||
| Medium Upright | P | ROM EXT |
Optional Fonts
Unprintable Regions
Left: 47 dots (0.157") portrait, 60 dots (0.2") landscape
Right: 95 dots (0.315") portrait, 60 dots (0.2") landscape
Top: 150 dots (0.5") portrait & landscape
Right: 150 dots (0.5") portrait & landscape
Continuous Feeding
Standard Trays: 1 paper tray (100 Sheets)
Manual Feeding
Through manual feed slot at
the back of printer.
Some paper sizes may require special software support.
| Message | Meaning | Resolution |
| 11 | Tray empty or removed | Add paper or replace tray |
| 12 | Printer engine power off | Close main body of printer |
| 13 | Paper Jam | Open printer, remove paper press continue |
| 14 | No EP cartridge installed | Install EP cartridge or make sure the installed cartridge is fully seated in the printer. |
| PC | Request for different size paper cassette | Insert correct paper tray or press continue to override |
| PF | Manual paper feed request or printer ready for manual feed | Feed paper through manual feed guides or press Continue to override. |
| PE | Envelope feed request, printer ready for envelope feed | Feed envelope through manual feed guides or press Continue to override |
| FC | Font cartridge was removed while printer was off-line and contained data | Insert font cartridge and press Continue |
| FE | Font cartridges were removed | Turn the printer OFF and then back ON |
| FF | Memory buffer overflow | Turn the printer OFF and then back ON |
| 20 & 21 ERROR | Printer out of memory | Press continue. Data may be lost. Print less complicated, less soft fonts, or at a lower graphics resolution |
| 22 & 40 ERROR | Communications error | Check baud rate and protocol |
| 41 ERROR | Print check error | Remove paper from output paper tray and press continue to resume printing. |
| 50, 51, 52, 53, 54, 55, 60, 61, 62, 63, 64, 65, 67 | Operational error | Contact HP Service |
Parallel
Availability: Standard
Connection: Centronics Female
Activation: Set SW1 switch 1 to the ON position
Serial
Availability: Standard
Connection: DB-25 Configured at factory for RS-232, RS-422 available by removing rear panel, and moving the jumpers from positions 1 and 3 (counting from left) to positions 2 and 4.
Activation: Set SW1 switch 1 to the OFF position